Plugging In And Ironing; Steam Ironing - Silvercrest SDBS 2800 A1 Bedienungsanleitung

Plugging in and ironing

Dry ironing without steam is possible at all
temperatures, steam ironing is only possible in the
red setting range on the temperature control
6 .
■ Insert the plug into a mains socket .
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
( symbol), the clothing item may not be
ironed . Ignoring this warning could lead to
permanent damage to the clothing item .
■ Check the care instructions on the labels in
garments to see if they are suitable for ironing,
and at which temperature setting .
Tempera-
Type of
ture control
material
symbol 6
MIN
acrylic, rayon
Silk, wool,
polyester mix
MAX
■ Select the appropriate temperature setting using
the temperature control 6 .
SDBS 2800 A1
Control
lamp
Type of
material 0
The appliance does
not heat up
Nylon,
NYLON
SILK/WOOL
fabrics
Cotton,
COTTON
viscose
Linen
LINEN
NOTE
While it is heating up, always place the iron on
its base 9 .
If you place the iron down on its sole q and
do not move it, the automatic switch-off will
be activated after 30 seconds (see chapter
"Automatic switch-off") and the appliance stops
heating .
The control lamp 0 for the set material type starts
flashing . As soon as set temperature has been
reached, the control lamp 0 for the set material
type lights up permanently and you hear a beep .
■ Wait until the control lamp 0 for the set material
type lights up permanently and you hear a
beep . You can start ironing .
■ To dampen the laundry, press the spray button
3 . Water is sprayed from the water jet 1 .
This function is suitable for very dry and heavily
crumpled garments .

Steam ironing

■ Press the steam quantity button 5 repeatedly
until the desired steam quantity is set .
Steam level
1
2
3
■ The temperature control 6 must be set to at
least the red setting range
steam will be produced .
Type of material
no steam
little steam
medium steam
lots of steam
. Otherwise no
GB │ MT │ 43 ■