Accessories; Use; Cleaning And Storage - Cleanmaxx Y8291BL Gebrauchsanleitung

EN

Accessories

• Use the crevice nozzle (11) to suck up dirt and dust. It is ideal for places which are
hard to get to, such as corners, crevices or recesses.
• The brush attachment (8) is placed directly onto the crevice nozzle. Use to remove
dust from delicate objects such as picture frames, lamp shades, keyboards, books
etc.
• Use the wet nozzle (7) to remove wet dirt and small quantities of liquid on smooth
surfaces.
• The wall bracket (13) with storage area for the nozzles (12) and a recess for the bar-
rel connector (14) of the power adapter is intended to be used for storing the device
in a way that saves space and for charging the battery.

Use

PLEASE NOTE!
■ Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■ Make sure that the MAX marking on the collecting container is not exceeded.
■ Always hold the device horizontally when liquids are sucked up. Make sure that
sucked-up liquids do not get into the motor unit.
1. Select a nozzle (see the "Accessories" chapter). The nozzles are inserted into the
suction opening (9) on the front of the device. The brush attachment (8) is placed
directly onto the crevice nozzle.
2. Switch on the device by sliding the On / Off switch (2) to position I. The device will
start vacuuming immediately.
3. Move the device over the surface to be cleaned.
4. After cleaning, switch off the device by sliding the On / Off switch to position 0.

Cleaning and Storage

PLEASE NOTE!
■ Never use soap or other cleaning products to clean the dust fi lter. This would cause
damage to the dust fi lter.
■ The dust fi lter must not be cleaned with water.
■ Only reassemble the device once all of the parts are completely dry.
■ Do not use any sharp or abrasive cleaning agents for cleaning. They could damage
the surfaces.
1. Hold the device securely by the handle (1) and press the release button (4). The col-
lecting container (6) is released and can be pulled off (Picture B1).
2. Pull the dust fi lter (10) with the fi lter holder out of the collecting container (Picture
B2).
3. Pull the dust fi lter out of the fi lter holder.
01463_Inlay_DE-EN-FR-NL_A5_V4.indb 18 01463_Inlay_DE-EN-FR-NL_A5_V4.indb 18
18
25.09.2020 14:43:28 25.09.2020 14:43:28