Installation C Controlled Entry And Exit - o&o CDS 1.3 Installations Und Bedienungs

12.3
This solution is recommended when you want to enter a reserved area in both directions activating a recognition command (radio
control, proximity key, magnetic keys, etc.).
ENTRY
The vehicle approaches the reserved area.
EXIT
Loops S1 and S2 also have a safety function in that they will not let the device move all the time the vehicle is on top.
DIMENSIONS
- Connect the N.O. contact of the coil S1 and S2 receiver to
input PDM.
- The dimensional values of the loops are only approximate.
We suggest installing the O&O "MAK-2" metal mass
detector.
INSTALLATION C
CONTROLLED ENTRY AND EXIT
PARAMETER DATA
 
 
 
 
- 31 -
When the vehicle is on loop S1 the
device will move down only after a
recognition command.
If the device is moving back up and
you want to lower it again the ve-
hicle must be on loop S1 and then
you must activate the recognition
command.
When the vehicle is no longer on
loop S2 the device will move back
up automatically after an adjusta-
ble pause time.
The vehicle approaches the reser-
ved area.
When the vehicle is on loop S2 the
device will move down only after a
recognition command.
If the device is moving back up and
you want to lower it again the ve-
hicle must be on loop S1 and then
you must activate the recognition
command.
When the vehicle is no
longer on loop S1 the
device will move back
up automatically after
an adjustable pause
time.
DESCRIPTION
Functioning logic: Automatic
Pause time
Opening consent and pause time reset
Radio channel 1: Open