Introduction; Main Characteristics; Technical Specifications; Installation Safety - o&o CDS 1.3 Installations Und Bedienungs

The CDS control unit has been developed to control automatic bollards.
- Microprocessor logic
- LEDs displaying input status
- Integrated radio receiver 433Mhz; 2048 codes
- 2-digit display
F3
F1
J5
J2
J2: 230Vac terminal board
J5: Power terminal board
J7: Outputs/accessories power supply terminal block
J9: Input/output terminal board
J10: Electrical brake/antenna terminal board
J13: DOMINO connector
In order to reach the level of safety required by current regulations, read the following prescriptions carefully.
1) Make all the connections in the terminal block after carefully reading the instructions given in this manual and observing the general
rules and technical standards governing electrical systems.
2) Upstream from the installation, fi t an omnipole miniature circuit breaker with a contact gap of at least 3 mm.
3) If there isn't one already, install a residual current device with a threshold of 30 mA.
4) Check the effectiveness of the grounding system and connect to it all the parts of the automation fi tted with a terminal or grounding
cable.
5) Fit at least one external warning device, such as a traffi c light or fl ashing light, along with a warning or danger sign.
6) Fit all the safety devices required by the type of installation, taking into consideration the risks it can cause.
7) Separate the power lines (min. sect. 1.5 mm
CDS
Instructions for installation and use

1. INTRODUCTION

2. MAIN CHARACTERISTICS

DL
F
J10
F2
J7
24 Vac
DL:
SW1: "START" control button
F1:
F2:
F3:
F,+,-: Programming push buttons

3. TECHNICAL SPECIFICATIONS

- Power supply:
- Motor output:
- Flashing light/traffi c light:
- Accessory output:

4. INSTALLATION SAFETY

2 ) from the low-voltage signal lines (min. sect. 0,5 mm
- Confi gurable outputs
- DOMINO connector
- TERMON
J13
SW1
J9
2-digit display
Line fuse: 5x20 6.3A F
Accessories and outputs fuse: 5x20 1A T
Low voltage fuse: 5x20 250mA T
230Vac +-10%, 50/60Hz
230Vac; 3A max
230Vac; 40W
24Vac; 1A max
- 19 -
LED
START
PDM
OPEN
FCA
CLOSE
FOTO
FCC
STOP
2 ) in the ducts.
EN