Radio Receiver; Receiver Technical Specifications; Radio Channel Functionality; Antenna Installation - o&o CDS 1.3 Installations Und Bedienungs

Description of level 3 parameters

· : Input polarity
This input may be confi gured provided that it is driven by N.O or N.C contacts.

· : Output polarity
The outputs can be confi gured as N.O. or N.C. but, in the event of a blackout the contacts open anyway.

· : Enable command during the pause time
Depending upon the setting of automation accepts or rejects commands for opening.

· : Special PDM functions
=1 PDM is used as opening consent. As long as it is not pressed, no opening command is accepted. When the PDM is
held down, no closure command is accepted so the bollard remains open.
=2 The PDM functions as described in point 1, but in case of automatic logic, the pause time is reloaded.
=3 The PDM function enables the TERMON system. Based on the setting of the  parameter, the closing or opening of
the contact activates or deactivates the TERMON system. This makes it possible to interface with a calendar or ther-
mostat with a volt free contact to optimise the heating system.

· : Pressure switch polarity (FCC input)
N.O.: Pressure switch type used until 2012.
N.C.: Pressure switch type used from 2013 on.
- Max. n° of radio transmitters that can be memorized:
- Frequency:
- Code by means of:
- N° of combinations:
Use an antenna tuned to 433MHz.
Connect the tuned antenna to the
antenna terminals using RG58 coaxial
cable.
In the case of standard installations where no advanced functions are required, it is possible to proceed to
manual storage of the transmitters, making reference to programming table A and to the example for basic
programming.
1) If you wish the transmitter to activate output 1, press pushbutton PR1, otherwise if you wish the
transmitter to activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press hidden key on the transmitter, LED DL1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL1 will fl ash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER
(MASTER).
In the case of manual programming, the fi rst transmitter assigns the key code to the receiver; this code is
necessary in order to carry out subsequent cloning of the radio transmitters.

8. RADIO RECEIVER

8.1 RECEIVER TECHNICAL SPECIFICATIONS

8.2 RADIO CHANNEL FUNCTIONALITY

Channel 1: Select the command from parameter R1
Channel 2: Closes the relay contact on the terminal block J7 "2nd CH RX"

8.3 ANTENNA INSTALLATION

J10

8.4 MANUAL PROGRAMMING

2048
433.92MHz
Rolling-code algorithm
4 billion
- 26 -
antenna cable RG58
Hidden key