J9 Inputs/Output Terminal Block; J10 Electric Brake Terminal Board/Antenna; J13 Programmer Connector - o&o CDS 1.3 Installations Und Bedienungs

START
N.O. input that operates the bollard's opening and closing. The command is ignored while opening.
PDM
Input programmable with -level 3, -level 3 and -level 2 parameters. May be duplicated in AUX output.
OPEN
N.O. input - opening only.
By keeping this input controlled, the automation performs the opening manoeuvre and will close automatically only when
the input is freed. Connect clocks, daily timers or weekly timers here if wanted.
CLOSE
N.O. input for closing. It allows the automation to be closed only if the safety devices have not triggered. Operating
mode programmable with parameter -level 1.
FTC
N.C. safety input (photocell). Enter the programme wanted by programming the -level 1 parameter. It triggers only in
the closing phase; it never triggers in opening.
STOP
N.C. safety input. When it is activated, the automation is immediately stopped. During the pause time, a stop control
eliminates the automatic closing, leaving the bollard open waiting for a command.
FCA
Limit switch N.C. input in opening. When activated the opening travel fi nishes.
FCC
Closure travel limit pressure switch input (see paragraph 7.4, parameter PP). Limit switch N.C. input in closing.
When activated the closing travel fi nishes.
6.5
EF
BT Input for anti blackout electric brake feeder (not available for GRIZZLY)
+
BAT
Permits the continuous power supply of the electric brake even without electrical energy, preventing the bollard
from lowering spontaneously in case of a blackout. Do not connect the batteries directly to this input but request
SHIELD
the original accessory O&O "BATT-US" code 303280
ANT
ANTENNA
Antenna connection for the integrated receiver.
6.4 INPUTS/OUTPUT TERMINAL BLOCK
J10
ELECTRIC BRAKE TERMINAL BOARD/ANTENNA
EF Electric brake output (not available for GRIZZLY)
Connection for two white power supply cables for the motor's parking electric brake.
Activation is possible only when the bollard is completely lifted.
J13
6.6 PROGRAMMER CONNECTOR
- 21 -