Programming; Basic Functions - o&o CDS 1.3 Installations Und Bedienungs

To access programming, press button F for 2 seconds.
Programming is divided into 3 levels.
To go to the next level keep key F pressed and press the + key (Sequence 1-2-3-1.......).
After selecting the level wanted, press push button F to display the functions available in consecutive order. Each time F is pressed
it corresponds to a function ( -  -  - .....)
With the function set, use the
The changes made to the parameters are active immediately but will be saved when exiting the menu, selecting the ST function
with key F.
PLEASE NOTE: If there is a black out when programming, all changes will be lost.
x 2"
F
1st level

programming

+
+
F
2nd level
programming
+
+
F
3rd level
programming
+
+
F
7. PROGRAMMING

7.1 BASIC FUNCTIONS

-
+
or key to change the values of the parameters (
Selects each
F
single 1st level
function
(see table par.6.2)
Selects each
F
single 2nd level
function
(see table par.6.3)
Selects each
F
single 3rd level
function
(see table par.6.4)
Example:
Selecting Output2 on closed arm:
A B
+
x 2"
+
F
F
2 nd level
Changes the va-
-
+
lues of each single
1st level function
(see table par.6.2)
F
Changes the va-
-
+
lues of each single
2nd level function
(see table par.6.3)
F
Changes the va-
-
+
lues of each single
3rd level function
(see table par.6.4)
F
C D
x 5 x 4
F +
 =arm closed
- 22 -
-
+
: ---... / : ...---).
F
E
x 3
F

- +
F
"ST" function
Exit and save
programming