Self-Learning Mode Programming; Connections For Simultaneous Operation; Troubleshooting Guide; Attention - o&o CDS 1.3 Installations Und Bedienungs

This mode is used to copy the keys of a transmitter already stored in the receiver memory, without acces-
sing the receiver.
The fi rst transmitter is to be memorised in manual mode (see paragraph 8.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press hidden key on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 10
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).

9. CONNECTIONS FOR SIMULTANEOUS OPERATION

The control unit CDS is used to operate up to a maximum of four bollards connected in parallel to thus obtain simultaneous operation
with just one control panel.
Use a junction box with adequate protection rating to complete the connections between the bollards in order to avoid cumbersome joints
near the control panel.
MOTOR CABLES:
CONDENSER CABLES:
ELECTRIC BRAKE CABLES:
LIGHT CABLES:
HORN CABLES:
FCA CABLES:
FCC CABLES (only for GRIZZLY):
BURGLAR CABLES:
HEATING ELEMENT CABLES:
In the case of a malfunction, check that the correct bollard was selected (paragraph 5)
- Dual fl ashing of the cover lights. Indicates that scheduled maintenance is required. Check the parameters , , 
- Triple fl ashing of the cover lights and status 14 or 15 on the display at the end of the manoeuvre. Check the opening travel stop and
the pressure switch contact at the end of closing (GRIZZLY only).
It is recommended to make an installation which has all the accessories necessary to ensure operation according to current provi-
sions, always using genuine O&O devices.
This equipment must be installed and used in strict compliance with the manufacturer's instructions. The manufacturer cannot be held
responsible for any damage deriving from improper or unreasonable use.
O&O srl disclaims all liability for any inaccuracies contained in this booklet and reserves the right to make changes at any time without
any prior notice whatsoever.

8.5 SELF-LEARNING MODE PROGRAMMING

Connect them in parallel respecting the polarity of the motors and joining the black cables, the brown
cables and the blue cables together.
Connect the condensers (with which each bollard is equipped) in parallel between the black cables
and the brown cables of the motor cables.
Connect the WHITE cables of the electric brakes in parallel (not available for GRIZZLY)
Connect the YELLOW cables of the LED lamps in parallel.
Connect the PINK cables of the horn contact in parallel.
Connect the GREEN cables of the opening end-of-travel devices in series.
Connect the WHITE cables of the closing travel stop in parallel (used until 2012)
Connect the WHITE wires of the closure limit switch (used from 2013) in series
Connect the ORANGE cables of the burglar device contact in series, if envisaged
Connect the RED cables of the heating element in parallel, if envisaged.

10. TROUBLESHOOTING GUIDE

11. ATTENTION

- 27 -