Plug-In Radio Receiver; Parts Assembly; Troubleshooting Guide; Attention - o&o LOG-BT Installations Und Bedienungs

The O&O single and dual channel radio receivers can be plugged into connector J4.
By means of jumpers JRX1 and JRX2 it is possible to select the 1st and 2nd radio channel function on start or open and close
respectively. Connect the tuned antenna to the radio receiver's antenna terminal.
1) The barrier fails to carry out the manoeuvre
Make sure the red safety device LEDS are on. Now check the condition of the safety devices and protection fuse F2.
2)
The motor goes to start in opening but then stops instantly or reverses the manoeuvre in closing without there being an obstacle.
Adjust the "torque" trimmer P1, turning it clockwise to increase force.
3)
The intermittence of the flashing light is irregular: two flashes yes and one no.
The barrier is working in black-out conditions, restore the mains in the case of a malfunction.
4) The control unit goes to the hold-to-run function.
It is likely that the PWM motor power control circuit has failed. Contact a specialized technician.
NOTE: Installation should always include all the accessories necessary to ensure operation in accordance with current laws
and standards, utilising always and only original O&O parts.
Always follow the manufacturer's instructions for using and installing this equipment as he cannot be considered liable for any
damages or injury arising from an improper or unreasonable use.
O&O srl declines all responsibility for any inaccuracies contained in this leaflet and reserves the right to make alterations at any
time without prior notice.

11. PLUG-IN RADIO RECEIVER

12. PARTS ASSEMBLY

13. TROUBLESHOOTING GUIDE

14. ATTENTION

O&O S.r.l.
Via Europa, 2 - 42015 Correggio (R.E.) Italy
Tel. +39 0522 740111 - Fax. +39 0522 631290
Internet: www.oeo.it - E-mail: oeo@oeo.it
Page. 11
Reg. n. 308
UNI EN ISO 9001:2000