Controlling The Volume Automatically - JVC KD-LX333R Bedienungsanleitung

Controlling the volume
automatically (Audio Cruise)
This section is only for KD-LX333R.
You can select the proper cruise mode for your
car.
This unit changes the volume level automatically
(at 3 possible levels) based on the driving speed
of your car by detecting the alternator's
generating frequency (Audio Cruise).
If you want to use this mode, follow the
procedure below. When shipped from the factory,
this mode is set to "CRUISE OFF."
• CRUISE 1: Select this if your car is
relatively quiet.
• CRUISE 2: Select this if your car is
relatively loud.
The volume increase rate is
twice as much as that of the
CRUISE 1 setting.
• CRUISE OFF: Cancels Audio Cruise.
1
Press and hold SEL (S) for more
than 2 seconds so that one of the
PSM items appears on the display.
(See pages 25 and 26.)
SEL
S
2
Select "CRUISE" if not shown on
the display.
3
Select the desired setting.
As you turn the control dial, the Audio Cruise
mode changes as follows:
CRUISE 1
CRUISE OFF
4
Finish the setting.
SEL
S
To adjust the volume increase rate
If you find Audio Cruise increases (or decreases)
the volume either too much or too little as the
driving speed changes, you can adjust the
increase rate by changing the boost level.
To change it, follow the procedure below.
• See also "Changing the general settings
(PSM)" on page 25.
1 Press and hold SEL (S) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2 Press
"CRUISE" appears on the display.
3 Turn the control dial to select either
"CRUISE 1" or "CRUISE 2."
¢ (or 4
4 Press
The current boost level also appears on the
display.
5 Turn the control dial to select the desired boost
level (among 01 to 15).
6 Press SEL (S) to finish the setting.
CRUISE 2
repeatedly until
) to select "BOOST."
29