Storing Stations In Memory; Fm Station Automatic Preset: Ssm - JVC KD-LX333R Bedienungsanleitung

2
Press and hold
until "M (manual)" starts flashing on
the display.
DIRECTORY
FILEDISC
TRACK
CD
3
Tune in to a station you want while
"M" is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (50 kHz intervals for FM
and 9 kHz intervals for AM – MW/LW) until
you release the button.
When an FM stereo broadcast is hard to
receive:
1
Press BAND MODE (M) while listening to an
FM stereo broadcast (the ST indicator lights up
while receiving an FM stereo broadcast).
"MODE" appears on the display, and the
number buttons can work as different function
buttons.
2
Press MONO, while "MODE" is still on the
display, so that the MO indicator lights up on
the display.
The sound you hear becomes monaural but
the reception will be improved (the ST indicator
goes off).
Each time you press the button, the MO
indicator lights up and goes off alternately.
10
¢ or 4
¢ to tune in to
Press
stations of higher frequencies.
Press 4
to tune in to
stations of lower frequencies.

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM
band (FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
1 Press SOURCE ATT to
ATT
SOURCE
2 If necessary, press and
BAND
MODE
M
Each time you press and hold the button,
the FM band changes as follows:
FM1
2
Press and hold both buttons for
more than 2 seconds.
SSM
BAND
DISP
MODE
D M
DIRECTORY
FILEDISC
TRACK
CD
"SSM" appears, then disappears when automatic
preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons
— No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
select FM as the source.
hold BAND MODE (M) to
select the FM band
number (FM1, FM2 or
FM3).
FM2 FM3