Manual Preset; Tuning In To A Preset Station - JVC KD-LX333R Bedienungsanleitung

Manual preset

You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (in this example,
FM1).
1 Press SOURCE ATT to
ATT
SOURCE
2 Press and hold BAND
BAND
MODE
M
2
Tune in to a station (in this example,
of 88.3 MHz).
Press
stations of higher frequencies.
Press 4
stations of lower frequencies.
DIRECTORY
FILEDISC
TRACK
CD
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
EQ
1 7
DIRECTORY
FILEDISC
TRACK
CD
"PI" flashes for a few seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
select FM as the source.
MODE (M) repeatedly to
select the FM1 band.
¢ to tune in to
to tune in to

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on pages 10 and 11.
1
Select the band.
1 Press SOURCE ATT to
ATT
SOURCE
2 If necessary, press and
BAND
MODE
M
Each time you press and hold the button,
the FM band changes as follows:
FM1
2
Select the number (1 – 6) for the
preset station you want.
EQ MONO
7 8 9
1 2 3
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce
this interference noise (the initial setting
when shipped from the factory). However, in
this case, the sound quality will be degraded
and the stereo effect will be also lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
"To change the FM tuner selectivity — IF
FILTER" on page 28.
select FM or AM as the
source.
hold BAND MODE (M) to
select the FM band
number (FM1, FM2 or
FM3).
FM2 FM3
INT RPT RND
11 6 12
10 5
11