External Component Operations; Playing An External Component; Using A Subwoofer (Only For Kd-Lx333R) - JVC KD-LX333R Bedienungsanleitung

EXTERNAL COMPONENT OPERATIONS

SEL
S
SEL
S
Playing an external
component
When connecting an external component, you
can select the component as the sound source.
Notes for KD-LX333R:
• For the external component connection, see the
Installation/Connection Manual (separate
volume).
• If the input level of the external component
connected to the LINE INPUT plug is not high
enough, increase the input level properly.
Without adjusting the input level, you may be
surprised at a loud sound when you change the
source from the external component to another.
(See "To adjust the line input level –– LINE
ADJ" on page 28.)
Notes for KD-LX111R:
• For connecting the external component, you
need to use the Line Input Adaptor KS-U57 (not
supplied). See the Installation/Connection
Manual (separate volume).
• Before operating the external component using
the following procedure, select the external
input correctly. (See "To select the external
component to use –– EXT INPUT" on page 28.)
1
Select the external component.
Each time you press the button,
ATT
SOURCE
the source changes as described
on page 7.
2
Operate the external component.
BAND ATT
EQ MONO
TP/PTY DISP MODE
8 9
7
T D M
SOURCE
SSM
BAND
TP/PTY DISP
MODE ATT
SOURCE
T D M
Press ON CLOSE to
turn on the power.
INT RPT RND OFF
12
MONO INT
EQ
1 2 8 3
7 9 10
Using a subwoofer
This section is only for KD-LX333R.
By connecting a subwoofer to the SUBWOOFER
OUT plugs on the rear, you can enjoy enhanced
bass sounds and a more realistic theater
atmosphere in your car.
• Refer also to the instructions supplied with
your subwoofer.
When a subwoofer is connected to this unit, do
the following as required.
To set the subwoofer cutoff frequency, see
"To select the subwoofer cutoff frequency —
WooferFreq" on page 28.
To adjust the subwoofer output volume, see
"Adjusting the sound" on page 22.
OFF
RPT RND
5 6 12
11
37