Activating The Level Meter - JVC kd-lh1000r Bedienungsanleitung

Activating the level meter

You can show the level meters on the display
while playing any source. This unit is equipped
with three level meter patterns.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press MODE (M).
"Mode" appears on the display.
2
Press EQ (equalizer) twice while
"Mode" is still on the display.
The last selected level meter
appears on the display.
3
Select the level meter pattern you
want.
As you turn the control
dial, the level meters
change as follows:
The list below shows the preset value settings for each sound mode (see also page 25).
Sound
C.Freq.
modes
Flat 50 Hz
Hard Rock 80 Hz
R & B 80 Hz
Pop 120 Hz
Jazz 80 Hz
Dance Music 50 Hz
Country 50 Hz
Reggae 80 Hz
Classic 120 Hz
User 1 50 Hz
User 2 50 Hz
User 3 50 Hz
Off Level 1
Level 3 Level 2
Preset values
Low
Q (Width) Level
Q1 +00
Q2 +03
Q3 +03
Q1 +02
Q1 +03
Q2 +04
Q4 +02
Q1 +03
Q1 +03
Q1 +00
Q1 +00
Q1 +00
Level Meter 1:
The audio level meter fluctuates vertically.
Level Meter 2:
The speaker on the display vibrates as input
audio level changes.
Level Meter 3:
The left and right audio level meters appear.
• If the small animation display is selected, only
one audio level meter can be shown.
Mid
C.Freq. Q (Width)
700 Hz Q1
700 Hz Q1
2 kHz Q2
2 kHz Q2
1 kHz Q1
700 Hz Q1
700 Hz Q1
2 kHz Q2
1 kHz Q1
700 Hz Q1
700 Hz Q1
700 Hz Q1
High
Level C.Freq. Level
+00 8 kHz
+00 8 kHz
+01 12 kHz
+01 12 kHz
+01 8 kHz
–02 8 kHz
+00 12 kHz
+02 12 kHz
+00 8 kHz
+00 8 kHz
+00 8 kHz
+00 8 kHz
+00
+02
+03
+02
+03
+01
+02
+02
+02
+00
+00
+00
27