Electrical Connection On Unfinished Walls From Below With Short Power Cable; Electrical Connection On Finished Walls - STIEBEL ELTRON DHE 18 Bedienung Und Installation

INSTALLATIoN
Installation alternatives
13.2 Electrical connection on unfinished walls from
below with short power cable
f Reposition the mains terminal further downwards. To do this, f
undo the fixing screw. Secure the mains terminal in place.

13.3 Electrical connection on finished walls

Note
This type of connection changes the IP rating of the ap-
pliance.
f Change the type plate. Cross out "IP 25" and mark f
the box "IP 24". Use a ballpoint pen to do this.
86 | DHE
30
1 Cable grommet
Electrical connection on finished walls
Positioned in lower section of appliance
Positioned in upper section of appliance
f Prepare the power cable. Fit the cable grommet. f
Material losses
!
If you break out the wrong knock-out in the back panel/
appliance cover by mistake, you must use a new back
panel/appliance cover.
f Cleanly cut and break out the required cable entries from the f
back panel and appliance cover (for the positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
f Route the power cable through the cable grommet. f
f Connect the power cable to the mains terminal. f
A
1
Dimension A
160
110
www.stiebel-eltron.com