STIEBEL ELTRON DHE 18 Bedienung Und Installation Seite 79

INSTALLATIoN
Installation
f Pull the cable grommet over the cable sheath of the power f
cable. For large cable cross-sections, enlarge the hole in the
cable grommet if necessary.
f Remove the transport protection plugs from the appliance f
pipe connections.
f Bend the power cable 45° upwards. f
f Route the power cable and cable grommet through the back f
panel from the rear.
f Install the appliance on the threaded studs of the wall f
mounting bracket.
f Press the back panel firmly into place, aligning it correctly. f
www.stiebel-eltron.com
f Lock the fixing toggle by turning it 90° clockwise. f
f Pull the cable grommets into the back panel until both lock- f
ing tabs engage.
19
3 Nm
5 Nm
f Fit the pipe connections with flat gaskets onto the water f
connections.
f Open the 3-way ball shut-off valve or the shut-off valve in the f
cold water inlet line.
24
DHE | 79