Initial Start-Up - STIEBEL ELTRON DHE 18 Bedienung Und Installation

INSTALLATIoN
Commissioning
Changing the connected load via jumper slot; only with
DHE 18/21/24
If you select a connected load other than the 21 kW factory setting
for appliances with selectable connected load, you will need to
reposition the jumper.
f Install the jumper in the required position on the pin strip. f
Jumper position Connected load
1 18 kW
2 21 kW
3 24 kW
No jumper 18 kW
82 | DHE
1
2
3

11.2 Initial start-up

f Open and close all connected draw-off valves several times, f
until all air has been purged from the pipework and the
appliance.
f Carry out a tightness check. f
f Activate the safety switch by firmly pressing the reset button f
(the appliance is delivered with the safety switch disabled).
≥ 60 s
www.stiebel-eltron.com