STIEBEL ELTRON DHE 18 Bedienung Und Installation Seite 69

oPERATIoN
Settings and displays
Menu Description
P 12 Backlighting
P 13 Reduce backlighting
P 14 Wireless module
4.9.3 Deactivating the parameter menu
f Exit the menu item by pressing "i" and holding for more than f
5 seconds. Alternatively: The system exits the menu item au-
tomatically 30 seconds after the setting has been completed.
www.stiebel-eltron.com
Selectable display | Explanations
setting
Auto | On You can adjust the display backlight.
- If "Auto" is selected, the backlight is switched on during heating
operation and each time an action is performed. If no action is per-
formed for 30 seconds, the backlight is switched off again.
- If you select "On", the backlight will remain on constantly.
100 % | 20 % ( ) You can select 2 levels of brightness for the backlight.
After installation of a wireless module (with or without paired wire-
less remote control) in the appliance, menu item P 14 is enabled and
"rc" appears on the programming unit display. You can pair one or
more wireless remote controls; to do so, follow the pairing procedure
on the appliance and the wireless remote control.
Pressing "1" on the appliance for longer than 5 seconds starts the
pairing process, which is shown on the programming unit of the ap-
pliance by a progress bar on the display and the operating LED flash-
ing. Start the pairing process on the wireless remote control as de-
scribed in the relevant operating instructions. After successful pairing,
the operating LED on the appliance flashes briefly. An unsuccessful
pairing attempt is automatically terminated after 30 seconds.
Pressing "2" on the appliance for longer than 5 seconds unpairs all
connected wireless remote controls. During unpairing, "rc0" appears
on the display of the programming unit for 5 seconds, then "rc" again.
Symbol |
display
DHE | 69