Alternative Installation Methods; Electrical Connection From Above On Unfinished Walls; Electrical Connection On Unfinished Walls With Short; Power Cable - STIEBEL ELTRON DHB-E 18/21/24 LCD Bedienung Und Installation

INsTALLATIoN

Alternative installation methods

13. Alternative installation methods
Overview of the alternative types of installation
Electrical connection
On unfinished walls, connected from above
Unfinished walls, from below, short power cable
Installation on finished walls
water connection
Installation on finished walls
other
Installation with offset tiles
Pivoting appliance cover
WARNING Electrocution
Before any work on the appliance, disconnect all poles
from the power supply.
13.1 Electrical connection from above on unfinished
walls
140
30
1 Cable entry installation aid
f Prepare the power cable. f
1 Cable routing
f Reposition the mains terminal from the bottom to the top. To f
do this, undo the fixing screw. Turn the mains terminal with
connecting cables 180° clockwise. Route the cable around
the cable guide when doing so. Secure the mains terminal in
place.
f Replace the cable grommets. f
f Install the cable grommet downwards from above. f
f Pull the cable grommet over the cable sheath of the power f
cable.
f Install the appliance on the threaded studs of the wall f
mounting bracket.
f Push the back panel firmly against the wall. Lock the fixing f
toggle by turning it 90° clockwise.
www.stiebel-eltron.com
f Pull the cable grommets into the back panel, until both lock-
f Connect the power cable to the mains terminal.
IP rating
IP 25
IP 25
IP 24
13.2 Electrical connection on unfinished walls with
IP rating
IP 24
IP rating
IP 25
IP 25
f Reposition the mains terminal further downwards. To do this,
1

13.3 Electrical connection on finished walls

1
1 Cable grommet
Dimension A
160
110
f Prepare the power cable. Fit the cable grommet.
f Cleanly cut and break out the required cable entries from the
f Route the power cable through the cable grommet.
f Connect the power cable to the mains terminal.
f
ing tabs engage.
f
WARNING Electrocution
The connecting wires must not protrude beyond the level
of the mains terminal.
short power cable
f
undo the fixing screw. Secure the mains terminal in place.
Note
This type of connection changes the IP rating of the ap-
pliance.
f Change the type plate. Cross out "IP 25" and mark f
the box "IP 24". Use a ballpoint pen to do this.
30
Electrical connection on finished walls
Positioned in lower section of appliance
Positioned in upper section of appliance
f
Material losses
!
If you break out the wrong knock-out in the back panel/
appliance cover by mistake, you must use a new back
panel/appliance cover.
f
back panel and appliance cover (for the positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
f
f
A
1
DHB-E LCD | 33