Program Execution - Sony LH71A Bedienungsanleitung

8-2-2. Program Execution

This executes the entered and edited programs.
1
Press the key. (
2
Press the key.
3
Enter the start No. of the program to be executed.
4
Press the key. (RUN lamp flashes)
5
Move the measuring unit to the start position, and press
the key.
The displacement of the first step will be displayed.
6
Move the measuring unit until the value (displayed shift
value) becomes approximately zero (within ±3 counts).
A beep tone will sound, and the NEXT lamp will flash.
7
Press the key.
The displacement of the next step will be displayed.
8
Repeat steps 6 and 7.
9
When the program ends,
* When you press the
executed once again.
10
Press the key. The system exits the program mode.
* If you press the
key during the program mode, the coordinates corresponding to the time at which
the start position was defined as the reference will be displayed.
Application: Mirror Image
When machining the applicable shape with respect to the X-axis and Y-axis, you can perform mirror
image machining.
Before executing the program, press the
Each time the key is pressed for the axis using the mirror image value, the indicator switches to
(reversed), (original). Use the
* You can check the mirror image setting by pressing the
X and Y axes are both reversed
with respect to the program
LH71A / LH72
lamp lights up)
will be displayed, and the current value will be displayed.
key, the step No. will be displayed, indicating that the program can be
key to switch to mirror image selection mode.
key to finalize the setting.
Y-axis
X-axis only is reversed with
respect to the program
X:
Y:
X:
Y:
Display
r
r
key during program execution.
Created by the program
X:
Y:
X-axis
X:
Y:
Y-axis only is reversed with
respect to the program
8. Applied Functions
(Current value
display)
(Current value
display)
(Example:
10.000)
(Example:
20.000)
8-9
(E)