Sony LH71A Bedienungsanleitung Seite 133

Tool offset (tool No. 2 ~)
<Setting a tool offset>
1
Press the key. (
2
Press the key of the third axis.
3
Enter the tool offset No. to be set.
4
Use the key to finalize the setting.
5
Press the key corresponding to the axis to be set.
6
Use the numeric key to enter the value.
7
Use the key to finalize the setting.
The current value is set as a tool offset value.
The tool offset is set, and the difference from the tool
master is stored as the offset value.
8
Using the key, select the axis to be set, and set it in the
same way. (Max 98)
9
Press the key.
The system exits the datum point mode. (
<Editing a tool offset>
You can edit a stored offset value.
1
Press the key. (
2
Press the key. (Shows the tool offset value)
3
Press the key of the third axis.
4
Enter the tool offset No. to be set.
5
Use the key to finalize the setting.
6
Press the key corresponding to the axis to be edited.
7
Use the numeric key to enter the value.
8
Use the key to finalize the setting.
9
Press the key. Editing of the tool offset is completed,
and the current value is displayed.
n
ABS indicator remains on during datum point mode.
The tool master (No. 1) is used as the basis of linear compensation.
(Position of tool master value 0 = Compensation amount 0)
LH71A / LH72
lamp lights up)
lamp goes out)
lamp lights up)
Display
(Current value
display)
(Example: No. 2)
(Example: 100.000)
Display
(Current value
display)
(Example: No. 2)
(Example: 20.000)
7. Operation Method
7-11
(E)