Sony LH71A Bedienungsanleitung Seite 138

7. Operation Method
3
Move the measuring unit, the count is held when the unit passes
through the reference point. (Axis label flashes)
* When the reference point is detected, a beep tone is emitted.
4
Press the , and then press the
The held value is saved as the offset, and the display hold is
cancelled.
5
Press the key. The system exits the reference point mode.
( lamp goes out)
<Relocation of the reference point offset (reference point load)>
Restore the reference point offset (L). When the reference point is detected, counting starts.
Milling Machine
Machining Measuring unit
datum point reference point
1
Press the key.
2
Press the , and then press the
The stored offset value (value displayed when the reference
point is loaded) is displayed.
3
Press the key.
A reference point wait status is activated. (
4
Move the measuring unit until it goes past the reference point.
When the reference point is detected, a beep tone is emitted.
* When the reference point is detected, counting starts.
5
Press the key to exit the reference point mode.
( lamp goes out)
7-16
(E)
key.
Lathe
key.
value flashes)
(Example: The
distance from the
reference point to
the datum point (L)
is displayed.)
(Current value
(ABS))
Workpiece
Measuring unit Machining
reference point datum point
Display
r
(Example: Current
value)
(Example: Distance
from the reference
point to the datum
point)
(Flashes)
LH71A / LH72