Sony LH71A Bedienungsanleitung Seite 154

8. Applied Functions
Application (LH71A-2, LH71A-3)
If you press the key instead of entering a numerical value, the BOLT, LINE and ARC lamps will
flash in that sequence. If you then press the
the program is running. The parameters that are used during program execution are those that have been
input in advance. If the parameters have not been input,
execution.
m
• Unless you press the
In step 9, be sure to confirm that
pressing the key,
displayed.
• To enter another program, go to the next step and enter in the same way.
• You cannot insert a new program into an existing program.
If it is necessary to add a new program, either re-input the existing program, or input a dummy step
(displacement zero) in advance. This will enable you to add bolt hole circles and other steps later on.
8-8
(E)
key, you can incorporate BOLT, LINE and ARC while
key, the entered program will not be finalized.
is displayed. If you ended the program input without
which indicates the end of the executed program will not be
will be displayed during program
LH71A / LH72