Sony LH71A Bedienungsanleitung Seite 139

<Inputting/restoring the reference point offset>
Enter the reference point offset (L). When the reference point is
detected, the count starts.
1
Press the key. (
2
Press the , and then press the
The stored offset value (value displayed when the reference
point is loaded) is displayed.
3
Enter the offset using the numeric key.
4
Press the key.
A reference point wait status is activated. (
5
Move the measuring unit until it goes past the reference point.
When the reference point is detected, a beep tone is emitted.
* When the reference point is detected, counting starts.
6
Press the key to exit the reference point mode.
( lamp goes out)
n
If the reference point of the measuring unit has directionality, be
sure to always load the reference point from the same direction.
When setting the segmented error compensation function, see
"5-5-2. Segmented Error Compensation".
<Editing the reference point offset>
Editing the set reference point offset (L).
1
Press the key. (
2
Press the key.
The stored reference point offset is displayed.
3
Press the key.
4
Edit the offset using the numeric key.
5
Press the key to finalize the offset.
6
Press the key.
Editing is completed, and the current value is displayed.
( lamp goes out)
LH71A / LH72
lamp lights up)
key.
value flashes)
lamp lights up)
Display
r
(Current value
(ABS))
(Example: Distance
from the reference
point to the datum
point)
(Example: 100.000)
(Flashes)
Display
r
(Current value
(ABS))
(Example: 50.000)
7. Operation Method
7-17
(E)