Installation And Connection Of Unit; Accessories; Placement - Sony LH71A Bedienungsanleitung

4. Installation and Connection of Unit

4-1. Accessories

Ground wire
Anchor bolts
Instruction Manual
Remote reset connector

4-2. Placement

Environmental conditions
• Ambient temperature: 0 – 40°C (32 to 104°F)
• For indoor use (avoid exposure to direct sunlight)
• Install the counter unit so it is protected from coolant, machine oil, chips and the like
• Install the counter unit at least 50 cm from power switchboards, welders, motors and the like
Notes
• Do not completely cover the counter unit with a vinyl cover or put it in a sealed case.
• If the counter unit's power is suddenly cut off, or if the voltage temporarily falls below the usable range,
the alarm may sound and faulty operation may occur. If such a situation occurs, temporarily unplug the
AC adaptor, wait a few seconds, reinsert the AC adaptor and repeat the operation from the beginning.
Be careful where you
place the counter unit.
Switchboard
(Locate more than 0.5 m/20" away.)
Welder
LH71A / LH72
1
M4 x 16 2
1
1
Coolant
Machine oil
→
Motor
Install the counter unit so it is
protected from coolant, machine oil,
chips and the like.
Chips
Chips
4-1
(E)