Sony LH71A Bedienungsanleitung Seite 144

7. Operation Method
Centering the workpiece
= 100
1
Press the key of the axis to be used.
n
The axis is selected by pressing the
selected, all axes are switched simultaneously.
2
Press the key. (ABS lamp lights up.)
ABS mode is started.
n
If the ABS lamp goes out, press the
3
Press the key.
The axis label flashes.
4
Press the key.
The touch sensor radius value flashes on the display.
5
Touch the feeler ball of the touch sensor to the surface A of
the workpiece.
As soon as the workpiece is touched, a beep sounds and
counting is started.
A
Contact
6
Press the key.
The axis label flashes.
7
Press the key.
The current value flashes on the display.
8
Move the touch sensor to touch the surface B of the workpiece.
(The axis label flashes.)
As soon as the workpiece is touched, a beep sounds and
the display value is held.
A B
7-22
(E)
C
A B
Workpiece
Center
key. If no axis is
key again.
Direction of movement and polarity
Display
(Flashes)
Counting
(Current value flashes)
LH71A / LH72