Herunterladen Inhalt Inhalt Diese Seite drucken

Simple R Cutting Function - Sony LH71A Bedienungsanleitung

Anzeigeeinheit
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8-1-3. Simple R Cutting Function

This function can be used for rough cutting of an arc. This function is available for 2-axis and 3-axis
models only.
a) Cutting the outer diameter
Parameter input
1
Press the
key so that ARC flashes, and then press the
2
Select the plane
The options change each time the
3
Enter the radius
Make the entry based on the input units (mm (inch)) and minimum input resolution.
4
Enter the tool diameter
Make the entry based on the input units (mm (inch)) and minimum input resolution.
5
Enter the starting angle
6
Enter the Ending angle
Note) You cannot enter an angle smaller than the starting angle. (Except 0 degree)
7
Enter the pitch angle
Note) Pitch angle must be set within the angle between the starting and ending angle.
The angle between the staring and ending angle must be dividable by pitch angle.
Cutting ends before reaching the ending angle in case of indivisible setting.
Execution
1
Move to the center (start position), and then press the
2
The position of the No. 1 holes is displayed.
3
Move the machine to display "0".
4
Press
key and repeat above procedures by pitch angle.
5
After machining of the final position has been completed, press the
is displayed, and the current values are displayed.
<Repeat operation>
• Return to the starting position again.
• Press
key to repeat the process with same parameters.
x Example a-1
Parameter
Radius
Tool diameter
Starting angle
Ending angle
Pitch angle
90˚
Ending angle
Y
No. 4
No. 3
No. 2
30˚
30˚
30˚
R center
20
LH71A / LH72
. (for three-axis model)
key is pressed (1-2: X-Y plane, 2-3: Y-Z plane, 1-3: X-Z plane).
, and then press the
with "+", and then press the
, and then press the
, and then press the
, and then press the
: 20 mm
: φ6
: 0°
: 90°
: 30°
Starting angle
φ6
Tool diameter
No. 1
Starting angle
X
key (ARC lights up).
key.
key.
key. Input range: 0.00 to 359.99 degrees
key. Input range: 0.00 to 359.99 degrees
key. Input range: 0.01 to 359.99 degrees
key to execute.
key.
x Example a-2
Parameter
Radius
Tool diameter
Starting angle
Ending angle
Pitch angle
20
No. 1
180˚
30˚
30˚
No. 2
No. 3
No. 4
8. Applied Functions
: 20 mm
: φ6
: 180°
: 270°
: 30°
Y
R center
X
30˚
φ6
Tool
diameter
270˚
Ending angle
8-5
(E)

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lh72Lh71a-3t01

Inhaltsverzeichnis