Resetting The Basic Settings (Lh71A General-Purpose Applications And Milling Machine Function); Detailed Settings - Sony LH71A Bedienungsanleitung

5-2-2. Resetting the Basic Settings
When the basic settings are reset and finalized (FINISH), all detailed settings will revert to their factory default
settings.
Power ON
Basic
settings
Approx.
Model
2 seconds
1-axis/2-axis model
Destination
country
Measuring unit
resolution
or
Detailed
settings
Display
resolution
(Measuring unit
resolution)
For 2-axis and
3-axis models only
Display switching
(1-1, 2-2, 3-3)
For 1-axis and
2-axis models only
Axis label
switching
(1-X, 2-Y, 3-Z)
Scaling
(1.000000)
Compensation
value
(OFF)
Flicker control
(2)
Sleep
(OFF)
Touch sensor
radius
(5.0000) or
Start of operation
* When the segmented error compensation value is set,
LH71A / LH72 LH71A / LH72
the unit switches to reference point acquisition mode.
(LH71A general-purpose applications and milling machine function)
Standby key lamp
(Hold down for
(Lights up t flashes)
approx. 3 s.)
3-axis
model
2
Use to select setting content
3
Select axis
Use to select setting content
Performed for each axis. Use
Note 1
4
Select axis
Use and
Performed for each axis.
5
Select axis
Use to select setting content
Performed for each axis.
6
Select axis
Use to select setting content
Performed for each axis.
7
Enter the setting value
8
Use to select the setting (compensation), and then set each option
Select axis
9
Use to select setting content
0
Use to select setting content
qa
Enter the setting value
(When the display resolution is 0.001 mm)
* If you have already entered the "detailed settings", make a note of the
setting values before resetting or changing the "basic settings".
* The setting in parentheses ( ) is the factory setting.
* indicates the process when the setting does not
be changed.
1
Use to select
to expand the selection option.
Note 1: Pressing or
in the "basic settings", and switches the
setting mode to "detailed settings".
to select setting content
Enter the compensation value
Enter the Enter the
compensation value
position
is displayed,
1 Select
GENERAL
2 STD/US/JPN
3 0.1/0.5/1/5/10/
00.00.01/
00.00.10/
00.01.00/
00.10.00
or
<Expanded>
0.05/2/20/25/50/
100/01.00.00
cancels the changes
4 Setting at 3 or
higher/Diameter
display at 3
(except for
angle)/Polarity
5 IN-1/IN-2/IN-3/
IN -
6 X/Y/Z
7 0.100000 -
9.999999
8 OFF/LIN Err/
SEG Err
* See Part 5-5,
"Compensation".
9 OFF/1/2
0 OFF/1/5/10/30/
60
qa 1.0000 - 20.0000
or
5. Settings
5-5
(E)