Sony LH71A Bedienungsanleitung Seite 149

b) Equally-spaced, angle-specified holes
Parameter input
1
Press the key so that BOLT flashes, and then press the
2
Enter the diameter
Make the entry based on the input units (mm (inch)) and minimum input resolution.
3
Enter the number of holes
4
Enter the starting angle
5
Enter the Ending angle
Note) You cannot enter an angle smaller than the starting angle. (Except 0 degree)
Execution
1
Move to the center (start position) of the bolt hole circle, and then press the
2
The position of the No. 1 hole is displayed.
3
Move the machine to display "0".
4
Press key and repeat above procedures up to the number of holes.
5
After the final hole has been formed, press the
displayed.
<Repeat operation>
• Return to the center of the bolt hole circle again.
• Press
key to repeat the process with same parameters.
x Example b-1
Parameter
Diameter
Number of holes : 5
Starting angle
Ending angle
Y
No. 2
75˚
No. 3
Center
75˚
No. 4
LH71A / LH72
, and then press the
, and then press the
, and then press the
, and then press the
: 100 mm
: 30°
: 330°
75˚
No. 1
30˚
Starting angle
X
No. 5
330˚
Ending angle
75˚
key. (BOLT lights up)
key.
key. Input range: 2 to 360 holes
key. Input range: 0.00 to 359.99 degrees
key. Input range: 0.00 to 359.99 degrees
key. is displayed, and the current values are
x Example b-2
Parameter
Diameter
Number of holes : 3
Starting angle
Ending angle
90˚
Y
90˚
No. 2
Center
90˚
270˚
8. Applied Functions
key to execute.
: 100 mm
: 90°
: 270°
Starting angle
No. 1
X
No. 3
Ending angle
8-3
(E)