Installation; Removing/Inserting The Battery; Used Batteries - Scheppach PWS-115 Original Bedienungsanleitung

9.3 Test run for new grinding wheels
• Allow the right-angle grinder to run in idle for at least 1 minute with the
grinding or cutting wheel fitted in place.
• Replace vibrating wheels immediately.

10. Installation

m IMPORTANT
You must fully assemble the appliance before using it for the first
time!
10.1 Battery
To ensure that the Li battery pack provides long service, you should take
care to recharge it promptly. You must recharge the battery pack when
you notice that the power of the cordless equipment drops.

10.1.1 Removing/inserting the battery

• To remove the battery (8) from the appliance, press the release button
on the battery and pull out the battery.
• To insert the battery (8), place it on the guide track and push it back
into the appliance. It will audibly snap in.

10.1.2 Used batteries

If a fully recharged battery lasts for considerably shorter operating times,
the battery is used up and needs to be replaced. Only use an OEM bat-
tery pack replacement available from our Customer Service
10.2 Switches (Fig. 1)
The angle grinder is equipped with a safety switch (3) for accident pre-
vention and an on/off switch (4).
10.2.1 Switching on
In order to turn on the machine, press the safety switch (3) and the on/
off switch (4).
54 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58