Made For Iphone (Mfi); Replace The Battery - Cochlear Baha 5 Power Benutzerhandbuch

Made for iPhone (MFi)

Your sound processor is a Made for iPhone (MFi)
hearing device. This allows you to control your
sound processor and stream audio directly from
iPhone, iPad or iPod touch. For full compatibility
details and more information visit www.cochlear.
com.
1. To pair your sound processor turn on Bluetooth
on your iPhone, iPad or iPod touch.
2. Turn off your sound processor and go to
Settings > General > Accessibility on your
iPhone, iPad or iPod touch.
3. Turn on your sound processor and select
Hearing Aids in the Accessibility menu.
4. When displayed, tap on the sound processor
name under "Devices" and press Pair when
prompted.
Talk on the phone
See figure 7
For best results, use a Cochlear Wireless Phone
Clip or stream the conversation directly from your
iPhone. When using a normal handheld phone,
place the receiver near the microphone inlet of
your sound processor instead of near your ear.
Ensure the receiver does not touch the sound
processor as this may result in feedback.

Replace the battery

The visual indicators and beeps will alert you when
there is approximately one hour of battery power
remaining. At this time you may experience lower
amplification. If the battery runs down completely
the sound processor will stop working.
Use one of the batteries (zinc-air, non-
rechargeable) included in the sound processor kit
as a replacement. The batteries included in the
kit reflect Cochlear's latest recommendations.
Contact your hearing care professional for
additional batteries.
1. To replace the battery hold the sound processor
2. Gently open the battery door until it is
3. Remove the old battery and dispose of it
4. Remove the new battery from the packet and
5. Insert the battery into the battery compartment
6. Gently close the battery door.
Tips
• To maximise battery life, switch off the sound
• Battery life decreases as soon as the battery
• Battery life depends on daily use, volume
• If a battery leaks, replace it immediately.
See figure 8
with the front facing up.
completely open.
according to local regulations.
peel away the sticker on the + side.
with the + side facing up.
processor when it is not in use.
is exposed to air (when the plastic strip is
removed) so be sure to only remove the plastic
strip directly prior to use.
levels, wireless streaming, sound environment,
program setting, and battery strength.
English
7