Mounting The Pump On The Base Plate; Hose Connections - Steinbach Classic 310 Originalbetriebsanleitung

Mounting the pump on the base plate

1. Insert the threaded screws of the
screw set for fastening the pump
from below into the two hexagonal
holes in the base plate
2. Place the pump
so that the threads protrude
12
through the fastening opening in the
pump base.
3. Push the washer and then the serrated
lock washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
The base plate is connected to the filter vessel.

Hose connections

- Fasten all attached hose connections with hose clamps to ensure that the system
does not leak.
We recommend additionally sealing the hose connections with Teflon tape
- Use suitable pool hoses for the described connections.
Some hoses, such as the pressure hose, are very stiff. Place them in the sun
before use so that the heat makes them more flexible.
Connecting the return line
You can use hoses with diameters of 32 or 38 mm, or optionally attach an
adapter for INTEX pools/Steinbach 2" ext. thread x 1" int. thread
1. Press and hold down the valve lever
2. Set the valve lever to the "CLOSED" position and release it.
54
13
.
12
on the base plate
3
to the filter vessel
12
14
.
2
on the valve head
31
23
.
36
.
1
.