Winter Storage; Cleaning - Steinbach Classic 310 Originalbetriebsanleitung

9. Inside the filter vessel, pull the filter arms
10. Remove the screen.
11. Thoroughly rinse the screen and the filter arms under flowing water.
12. Rinse the filter vessel with clean water.
13. Carry out steps 4 to 12 as described in the "Preparing the filter vessel" section.
The filter medium is exchanged.

Winter storage

1. Switch the pump
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Uninstall the connecting lines to the pool and drain the hoses.
4. Loosen the drain screws
5. Remove the filter medium (see "Exchanging the filter medium" section).
If you are using filter balls, wash them by hand and let them dry completely.
6. Store the filter medium separately. It must not be stored in the filter vessel.
7. Rinse the filter system with tap water.
8. Let the filter system dry completely.
9. Press and hold down the valve lever
10. Turn the valve lever to the "WINTER" position and let go.
The device can be stored over the winter.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain water after each use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
off by pulling the power plug.
3
on the pump housing and completely empty the pump.
33
NOTICE!
off the screen
9
on the valve head
31
.
8
.
1
59