Steinbach Classic 310 Originalbetriebsanleitung Seite 52

12. If the vessel seal is not already fitted
on the valve head, guide the vessel
seal over the bottom of the valve
6
head .
1
13. Place the valve head on the filter
vessel.
14. Align the valve head so that the
"PUMP" connection points towards
the future position of the pump.
15. Place the locking ring
head and filter vessel connecting point.
9
16.
Insert the screws of the locking ring and tighten them clockwise.
17. Remove the bleeder screw
head by turning it counter-clockwise.
18. Wrap the manometer thread
Teflon tape .
23
19. Screw in the manometer at the removal
position of the bleeder screw by turning it
clockwise.
52
around the valve
7
on the valve
25
with
16
7
8
10
11