Preparing The Pump; Mounting The Pump On The Base Plate - Steinbach Comfort 50 Originalbetriebsanleitung

Preparing the pump

At the time of delivery, the pump is only partially assembled.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
1. Loosen the threaded ring
cover by turning it counterclockwise.
11
2. Lift the prefilter cover
ring off the pump housing.
3. Insert the large O-ring seal
groove on the pump housing.
4. Insert the prefilter
24
The prefilter is already inserted into the pump
at the factory.
5. Place the prefilter cover
housing.
6. Guide the threaded ring over the prefilter
cover.
7. Turn the threaded ring clockwise until it is
hand-tight.
8. Insert the small O-ring seal
9. Screw the hose connection clockwise into the prefilter cover until it is hand-tight.
10. Place the medium O-ring seal
11. Screw a hose adapter
The Comfort 50 filter system has the hose adapter assembled on the pressure hose.
The pump is ready for operation. You can now connect it to the lines.

Mounting the pump on the base plate

1. Insert the threaded screws of the screw set
for fastening the pump
two hexagonal holes in the base plate
2. Place the pump on the base plate
10
that the threads protrude through the
fastening opening in the pump base.
3. Push the washer and then the serrated lock
washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
.
6
The base plate is connected to the filter vessel.
on the prefilter
13
with the threaded
11
into the
17
into the pump.
on the pump
11
into the prefilter cover.
19
into the recess of the pump outlet
18
clockwise into the pump outlet until hand-tight.
12
from below into the
23
.
9
so
9
to the filter vessel
9
1
13
11
19
17
24
.
25
2
10
9
3
6
9
2
12
18
25
23
33