Mounting The Pump On The Base Plate - Steinbach Active Balls 50 Originalbetriebsanleitung

1. Loosen the threaded ring
prefilter cover
counterclockwise.
2. Lift the prefilter cover
threaded ring off the pump housing.
3. Insert the large O-ring seal
groove on the pump housing.
4. Insert the prefilter
The prefilter is already inserted into
the pump at the factory.
5. Check the O-ring seal for dirt or damage. Replace the seal if necessary.
6. Place the prefilter cover
7. Guide the threaded ring over the prefilter cover.
8. Turn the threaded ring clockwise until it is hand-tight.
9. Insert the small O-ring seal
10. Screw the hose connection clockwise into the prefilter cover until it is hand-tight.
11. Place the medium O-ring seal
12. Screw a hose adapter
The Active Balls 50 filter system has the hose adapter assembled on the pressure
hose.
The pump is ready for operation. You can now connect it to the lines.

Mounting the pump on the base plate

1. Insert the threaded screws of the
screw set for fastening the pump
from below into the two hexagonal
holes in the base plate
2. Place the pump
so that the threads protrude
9
through the fastening opening in the
pump base.
3. Push the washer and then the serrated
lock washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
on the
13
by turning it
11
with the
11
into the
16
into the pump.
21
on the pump housing.
11
into the prefilter cover.
18
into the recess of the pump outlet
17
clockwise into the pump outlet until hand-tight.
12
.
9
on the base plate
10
8
13
11
18
16
21
9
19
10
12
17
22
.
22
9
19
47