Filtering Time; Before First Use; Check The Following Before Start-Up; Mounting The Pump On The Base Plate - Steinbach Classic 250N Active Balls+ Originalbetriebsanleitung

WASTE
- The pool can only be drained up to the minimum water level at the height of the suction
line. Make sure to switch the pump off once this level is reached to prevent the pump
from running dry.
Use this mode to clean the pool in the case of heavy soiling.
The water is guided past the filter and discharged directly via the backwash line.
WINTER
- Never switch on the pump in this mode!
Use this mode to store the filter system in the winter.
The valve lever is in an intermediate position which relieves the inner valve components.

Filtering time

The pool's water content should be circulated at least twice in a 24 h period. In case of heavier
frequency, the pool water should be circulated 3 to 5 times per day.

Before First Use

Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
- Never operate water treatment system devices while persons are in the pool.
- Prevent any access to the pool for as long as water treatment system devices are in use.
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
- Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.

Check the following before start-up

- The device is out of the pool and the power cable is disconnected from the mains

Mounting the pump on the base plate

1. Insert the threaded screws of the screw set for
fastening the pump
hexagonal holes in the base plate
2. Place the pump
3
the threads protrude through the fastening
opening in the pump base.
3. Push the washer and then the serrated lock
washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
The base plate is connected to the filter vessel.
NOTICE!
NOTICE!
WARNING!
NOTICE!
from below into the two
10
.
9
on the base plate so that
9
to the filter vessel
9
1
.
2
27