Operation Of Steering Handle Lock Switch; Use Of Buttons - Sym WOLF SB125Ni Bedienungsanleitung

§OPERATION OF STEERING HANDLE LOCK SWITCH §
"Steering handle lock" position
 Turn the steering handle to left and press ignition switch key down. Push the key and turn to
"LOCK" position.
 The steering handle is locked in this position.
 Ignition switch key can be removed.
 When unlocking, simply turn the key from "LOCK" to "OFF".
The steering handle lock is located on the steering stem
directly below the steering head.
 Turn the steering handle fully to the left
 Insert the ignition switch key into the lock
 Turn the key clockwise, then the steering handle can be locked.
 Remove the Ignition switch key
 When unlocking, simply turn the key anti-clockwise
NOTE:
For preventing the vehicle to be stolen, lock the handle bar when parked.

After locked, turn of the handle bar left and right to make sure it

When leaving the vehicle, remember to remove the key

CAUTION:
Never operate the ignition switch key when the motorcycle is running. To turn the ignition switch

to the "OFF" position, will shut off the electrical system and that may result in a dangerous
accident. Therefore, the ignition switch can only be turned off after the motorcycle has been
completely stopped.
To prevent the motorcycle from be stolen, lock the steering when parking.

 Always remove the key and be sure to take the key away with you after locking the steering
handle before leaving your motorcycle.
If ignition switch remains in the "ON" position for a prolonged period after the engine has been

stopped, the battery's capacity will be reduced and this may affect the engine's start ability.
§USE OF BUTTONS
High/Low Beam Switch
 Engine Stop Switch
Switch to this position to turn off the engine when a state of emergency.
Switch to this position and the engine can be started.
Turn Signal
Switch
Horn Switch
Electrical
starter button
8
Steering handle lock
Engine Stop Switch