Driving In Grade; Transmission Operation; Correct Riding - Sym WOLF SB125Ni Bedienungsanleitung

§DRIVING IN GRADE §
Up Grade
Driving up a slightly grade can drive with high position gear.
Under heavy loading or steep grade driving condition, It
must drive with low gear.
Down Grade
Close the throttle and operate the brakes when driving
down a slight grade. Shift the gear to low gear in case of
heavy loading or driving down steep grade condition.
CAUTION:
 Braking must apply both the front and rear brakes.
§TRANSMISSION OPERATION §
 The change pedal is located on the left side of the
engine. Shift transmission to the lower gear when
driving hard or down grade.
 Squeeze the clutch lever fully, operate change pedal
to the proper position, then release the clutch lever to
make a gear change.
 Don't operate the transmission when the engine is not
running.
 Don't operate change pedal rudely, or the
transmission will be damaged.
 Shift the gear to the next lower position for overtaking
other vehicles.
This limit speed for shift to lower gear.
5 → 4
th th
4 → 3
th rd
3 → 2
rd nd
2 → 1
nd st
§CORRECT RIDING §
Optimum Start Riding
 Turn on the turn signal and make sure of no vehicle
coming behind before start riding.
Below 80km/h
Below 70km/h
Below 50km/h
Below 25km/h
13