Checking The Turn Signal Lights And Horn; Checking The Headlight And Tail Light; Checking The Brake Light - Sym WOLF SB125Ni Bedienungsanleitung

§CHECKING THE TURN SIGNAL LIGHTS AND HORN §
Turn the ignition switch key to the "ON" position.

Turn on the turn signal light switch, and make sure that

the front & rear and left & right signal lights flashes and
also check if the warning buzzer sounds.
Check turn signal light covers if they are dirty, crack, or

loosen.
Press horn button to check if it sound.

CAUTION:
 Specified specification bulbs should be used for
turn signal lights. Otherwise, the normal operation
of turn signal lights will be affected.
 Turn on the turn signal light before turning or
switching lane to warn driver of vehicles behind.
 Turn off the turn signal light immediately by
pressing its button down after using. Otherwise,
the flashing of twin signal lights may confuse the
drivers of vehicles behind.
§CHECKING THE HEADLIGHT AND TAIL LIGHT §
Turn the ignition switch to "on" position. Turn on the

headlight and taillight switch. Check if the headlight
and taillight come on.
Check the brightness and light angle of the front light

by wall to see if it is correct.
Check the light cover if it is dirty, crack, or loosen.

§CHECKING THE BRAKE LIGHT §
Turn the ignition switch key to the "ON" position, hold

the hand-braking levers for front and rear wheels.
Check if the brake lights come on.
Check the brake light cover if it is dirty, crack, or

loosen.
CAUTION:
Use only specified specification bulbs, do not use bulbs with different specifications to avoid

damaging electrical system, burning out bulbs, and discharging the battery.
Do not modify or add other electrical components to prevent over load or short circuit which may

result in a fire and burn down the motorcycle in serious cases.
24