Rear Cushion Hardness Setting; Checking And Changing Fuses; Checking The Turn Signal Lights And Horn - Sym CRUiSYM 300i Bedienungsanleitung

REAR CUSHION HARDNESS SETTING

The rear cushion is 4 stage adjustable type. It's set
at 3th stage when manufactured, and you can adjust
it depending on your need. Turn the adjust collar of
the cushion to adjust it's hardness.
CAUTION:
 Turn counterclockwise to harden it, and turn
clockwise to soften it.
 Mark sure adjust both cushion at the same time
to be sure the riding stability.

CHECKING AND CHANGING FUSES

Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one having the
same specified amperage rating . Using a fuse of more than 20 or 15 amperes, a brass or iron wire to
replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
 Remove the storage box, and you'll find the fuse box near light.
 Open the fuse box cover, and pull out the fuse. Check it for damage or broken.
 Fuses must be firmly secured with wire connectors when replacing. Loose connections will result in
overhead and damage.
 Use only parts having the specified specification to replace electrical components such as light bulbs.
Using parts not having the specified specifications for replacement may cause the fuse to blow and
over-discharge the battery.
 Avoid spraying water directly on or around fuse box when washing the scooter.
 Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes.

CHECKING THE TURN SIGNAL LIGHTS AND HORN

 Turn the ignition switch key to "
 Turn on the turn signal light switch, and make sure that the front & rear and left & right signal lights flashes
and also check if the warning buzzer sounds.
 Check turn signal light covers if they are dirty, crack, or loosen.
 Press horn button to check if it works.
CAUTION:
 Specified specification bulbs should be used for turn signal lights. Otherwise, the normal operation
of turn signal lights will be affected.
 Turn on the turn signal light before turning or switching lane to warn driver of vehicles behind.
 Turn off the turn signal light immediately by pressing its button down after using. Otherwise, the
flashing of twin signal lights may confuse the drivers of vehicles behind.
Fuse control box
" position.
21
10. Inspection and maintenance before riding
hard
soft
Burned fuse