Maintenance - PeakTech 1610 Bedienungsanleitung

1. Disconnect test leads from any live source, turn the rotary switch
to OFF and remove the test leads from the input terminals.
2. The battery cover is secured to the bottom case by a screw. Using
a Philips-head screwdriver, remove the screw from the battery
cover and remove the battery cover.
3. Remove the battery and replace with a new equivalent 9 V-battery.
4. Replace the battery cover and reinstall the screw.
Note: Batteries which are used up, dispose duly. Used up batteries are
hazardous and must be given in the for this being supposed collective
container.

8. Maintenance

Maintenance consists of periodic cleaning and battery replacement.
The exterior of the instrument can be cleaned with a dry clean cloth to
remove any oil, grease or grime. Never use liquid solvents or
detergents.
Repairs or servicing not covered in this manual should only be
performed by qualified service personnel.
All rights, also for translation, reprinting and copy of this manual or
parts are reserved. Reproductions of all kinds (photocopy, microfilm or
other) only by written permission of the publisher.
This manual considers the latest technical knowing. Technical
changings which are in the interest of progress, reserved.
We herewith confirm that the units are calibrated by the factory
according to the specifications as per the technical specifications.
We recommend to calibrate the unit again, after 1 year.
© PeakTech ® 02/2008/Th
-39-
PeakTech
®
Bedienungsanleitung /
Operation manual
Digital - Zangenmessgeräte /
Digital Clamp Meters
1610 / 1615 / 1625