Technische Daten - PeakTech 1610 Bedienungsanleitung

6.2. Current Measurements
WARNING! These Snap-arounds are designed to take current
measurements on circuits with a maximum voltage difference of
600 V AC between any conductor and ground potential. Using the
snap-around for current measurements on circuits above this voltage
may cause electric shock, instrument damage and/or damage to the
equipment under test. Before measuring current make certain that the
test leads are removed from the instrument.
The snap-around is overload protected up to 600 V AC for up to 1 Min.
Do not take current readings on circuits where the maximum current
potential is not known. Do not exceed the maximum current that this
instrument is designed to measure.
1. Set Function Switch to 40 A, 400 A or 1000A AC or 40A, 400A or
1000A DC (P 1615 / P 1625).
2. Press the trigger to open the transformer jaws and clamp them
around a conductor. Jaws should be completely closed before
taking a reading.
3. The most accurate reading will be obtained by keeping the
conductor across centre of the transformer jaws.
4. The reading will be indicated on the display.
5. Reduce the range setting if too high until a satisfactory best
resolution reading it obtained.
6.3. Resistance measurements
WARNING! Attempting resistance or continuity measurements on live
circuits can cause electric shock, damage to the instrument and
damage to the equipment under test. Resistance measurements must
be made on de-energized (DEAD) circuits only for maximum personal
safety. The electronic overload protection installed in this instrument
will reduce the possibility of damage to the instrument bus not neces-
sarily avoid all damage or shock hazard.
-35-

3. Technische Daten

Anzeige
3 ¾-stellige 17 mm LCD-Anzeige mit einer max.
P 1610:
Anzeige von 4000 und Anzeige der Funktions-
symbole
3 ¾--stellige 17 mm LCD-Anzeige mit einer max.
P 1615:
Anzeige von 4000 und Anzeige der Funktions-
symbole
3 ¾-stellige 15 mm LCD-Anzeige mit einer max.
P 1625:
Anzeige von 4000 und Anzeige der Funktions-
symbole; 42-Segment Analog-Balkengrafik
Polarität automatische Umschaltung (bei negativen Mess-
werten Minussymbol (-) vor der Messwertanzeige)
Überlastanzeige „OL" im Anzeigefeld
Batteriezustands- Batteriesymbol leuchtet bei ungenügender Bat-
anzeige teriespannung
Messfolge 2 x pro Sekunde, 20 x pro Sek. analoge
Balkengrafik (P 1625)
2 x pro Sekunde (P 1610, P 1615)
Abschaltautomatik P 1610: 30 Minuten / P 1615: 35 Minuten /
P 1625: 20 Minuten
Spannungsver-
sorgung 9 V-Blockbatterie
Max. Leiterdurch-
messer 30 mm
Betriebstemp-
bereich -10...50° C bei max. 85 % R.H.
Lagertemp.-
bereich -30...+60° C bei max. 85 % R.H.
-4-