PeakTech 1610 Bedienungsanleitung Seite 13

4.5. Widerstandsmessungen
Modell Bereich Auflösung
P 1610 400 Ω
100 mΩ
4 k Ω 1 Ω
40 k Ω 10 Ω
100 Ω
400 kΩ
4 MΩ 1 kΩ
40 MΩ 10 kΩ
P 1615 400 Ω
100 mΩ
1 Ω
4 kΩ
10 Ω
40 kΩ
100 Ω
400 kΩ
4 MΩ 1 kΩ
40 MΩ 10 kΩ
P 1625 400 Ω
100 mΩ
1 Ω
4 kΩ
10 Ω
40 kΩ
100 Ω
400 kΩ
4 MΩ 1 kΩ
40 MΩ 10 kΩ
Überlastschutz: 250 V AC/DC
Genauigkeit
± 1,0% v.M. + 4 dgt.
± 1,5% v.M. + 2 dgt.
± 2,5% v.M. + 3 dgt.
± 3,5% v.M. + 5 dgt.
± 1,0% v.M. + 4 dgt.
± 1,5% v.M. + 2 dgt.
± 2,5% v.M. + 3 dgt.
± 3,5% v.M. + 5 dgt.
± 1,0% v.M. + 4 dgt.
± 1,5% v.M. + 2 dgt.
± 2,5% v.M. + 5 dgt.
± 3,5% v.M. + 10 dgt.
-7-
(1) Current Clamp
(2) Clamp trigger
(3) P 1615: Data-Hold / Backlight
P 1625: Data-Hold
(4) Mode-select button
(5) P 1615: Hz%-button
P 1625: Peak-Hold-button
(6) LCD-Display
(7) COM-Input jack
(8) Rotary function switch
(9) Zero-button
(10) P 1615: Range select button
P 1625: Backlight
(11)VΩ-jack
COM Terminal
This is the negative (ground) input for all measurement modes except
current. Connection is made to it using the black test leads.
V/Hz/F/Ω Input Terminal
This is the positive input terminal for voltage, capacitance, frequency,
ohms and diode measurements. Connection is made to it using the red
test lead.
Display
The display indicates the measured value of a signal, function mode
and annunciator.
Function/Range selector rotary switch
This rotary switch selects the function and selects the desired range.
Range Button
Press RANGE button to select the manual range mode and Turn off
the "AUTO" annunciator. (The meter remains in the range it was in
when manual reading was selected).
In the manual range mode, each time you press (RANGE) button, the
range (and the input range annunciator) increments, and a new value
is press and hold down (RANGE) button for 2 seconds. The "AUTO"
annunciator turns back on.
-32-