Service; Cleaning The Fixture; Changing Of The Lens Module - JB-Lighting VaryLED 3*84 Bedienungsanleitung

Activate the standalone mode:
The standalone mode is activated in the menu: DMX/STANDALONE
independent if it was programmed manually or by a connected DMX board.
To enter menu DMX/STANDALONE press key "Menu" and afterwards key "+"
three times. You will find D
"Enter". Select standalone-function by pressing key "+" and press "Enter" one
time to activate.
Deactivate the standalone mode:
To deactivate standalone mode press "Enter" and key "-" one time. The display
will show: DMX MODE.
displayed Escape by pressing key "Menu". .

4. Service

4.1 Cleaning the fixture

WARNING: Disconnect fixture from mains, and allow
!
To ensure a long and satisfying performance of the fixture, check function of the
fans in the head and in the base from time to time. Most important: make sure
that there is no dust or fluff covering the air inlets.
To clean the fixture open lid of the head and the baseplate. Use a brush and a
vacuum cleaner to remove dust and fluff. Don´t damage or bend any parts.
Incompetend performace of the maintenance will invalidate the warranty claims.
Consult qualified service personnel.

4.2 Changing of the lens module

There are two lens modules with different beam angles available. The standard beam
angle is 10° the optional lens module offers a 25° beam angle. To change the modules
remove the 4 cross-heades screws on the front of the lens module and remove the
complete lens module. Insert the optional module paying attention to the orientation
of the reflector-clips which should face the base.
JB-lighting Lichtanlagentechnik GmbH Sallersteigweg 15 D-89134 Blaustein Telefon +49 (0)7304-9617-0
MX/STANDALONE displayed.
S-ALONE: 1 / 2 will be shown on the display.
Press key "Enter" again and find
unit to cool down for at least 10 minutes!
With direct view on the beam source use a
welding goggle of reduction 4-5 !
reflector-clip
To confirm press
DMX/STANDALONE
remove
cross-head screws
25