Lamp Control And Lamp Ignition - JB-Lighting Varyscan P3 Handbuch

Activate the standalone mode:
The standalone mode is activated in the menu: DMX/STANDALONE
independent if it was programmed manually or by a connected DMX board.
To enter menu DMX/STANDALONE press key "Menu" and afterwards key "+"
three times. You will find D
To confirm press "Enter".
Select standalone-function by pressing key "+" and press "Enter" one time
to activate. S-ALONE: 1 / 2
Deactivate the standalone mode:
To deactivate standalone mode press "Enter" and key "-" one time.
The display will show:
Press key "Enter" again and find
Escape by pressing key "Menu"

3.5 Lamp control and lamp ignition

There are differnt modes for lamp ignition and lamp control available:
Lamp ignition configuration is set in the fixtures personality configuration in menu
LAMP MODE
possibility no.1: The lamp ignites as soon as the fixture powers up (AUTO START)
possibility no 2: The lamp ignites as soon as the fixture powers up and a DMX value
possibility no 3: The lamp ignites so soon as the fixture powers up and any DMX signal
Configuration of lamp control:
The lamp control configuration is independent to the lamp ignition mode.
The lamp control is based on DMX values. It is used to switch off the lamp by
means of the control console.
To enable the lamp control mode enter personality configuration of the fixture.
Activate menu LAMP ON/OFF DMX
If the option OFF
be controlled (switched off)
If the option ON
discribed before and it can always be controlled (switched off) by DMX if there is a
DMX value send between 232-239 on channel no. 5 for more than 3 seconds.
MX/STANDALONE displayed.
will be shown on the display
DMX MODE
DMX/STANDALONE
between 248-255 is send on channel no. 5 (AUTO OFF).
is connected to the fixture
is selected in LAMP ON/OFF DMX
by DMX if possibility no. 2 is selected.
is selected in LAMP ON/OFF DMX menu,
displayed
(AUTO DMX) .
menu, the lamp can only
the lamp will ignite like
27