easydriver infinity 3.5 Montageanweisung Und Bedienungsanleitung Seite 38

Appendix A2-A4 Comments and recommendations + A5 FAQ`s
A2 Manually swivelling the drive rollers on or
off (emergency operation of motor drive, see Figure
3.3 - 3.4)
Lift out the operating lever on the reverse side of the
housing with a suitable screwdriver, so that it can be
turned over the housing (Figure 3.3).
Turn clockwise = Swivelling ON (Figure 3.4).
Turn anti-clockwise = Swivelling OFF (Figure 3.4).
A3 Maintenance
Have your easydriver maintained and visually inspec-
ted once a year:
• Clean the entire manoeuvring drive.
• Provide all moving joints and parts with appropri-
ate, acid-free lubricant, e.g. silicon spray.
• Check the distance of the drive rollers to the tyres
and the tyre pressure.
• Visual inspection of the cabling and the electrical
connection for loose connections and damage.
• Check the battery voltage.
• Check before each drive whether the manoeuvring
drive is free of dirt, sand and branches.
Contact your dealer in the event of faults.
A4 Comments and hints
• You can use the easydriver to couple it to your to-
wing vehicle at any time.
• Ensure that both drive units are uncoupled before
driving off with your towing vehicle (Figure 3.1 =
OFF).
• Use wedges in front of curbs or similar obstacles.
• Store the remote control and the documentation in
a dry place..
• The easydriver is equipped with electrical overload
protection and automatically switches off when it
is overloaded.
• Synchronisation must be performed when the re-
mote control or the base station is replaced (Ap-
pendix A1).
• Replace the batteries in your remote control as re-
quired (Figure 2.2).
GB16
A5 FAQ's
The easydriver cannot be mounted on the chassis:
• The easydriver series was designed for attachment
to a standard chassis. Additional adapters are avai-
lable on request.
The spare wheel obstructs the installation of the ea-
sydriver:
• Move the spare wheel carrier by using an adapter.
The easydriver twists very strongly:
• Take note of the minimum frame strength (see Fi-
gure 8.1, Dimension C ). An optional frame rein-
forcement must be installed as required..
The easydriver cannot be switched on by remote con-
trol:
• The main switch is not switched on.
• The remote control is not synchronised with the
base station.
• The voltage supply is too low.
The drive roller slips on the tyre:
• The distance between drive roller and tyre has
been de-adjusted. The distance must be 15-20
mm.
• Check the tyre pressure and increase as required.
The vehicle jerks during manoeuvring:
• The supply voltage or the battery capacity is too
low. The minimum battery capacity should be
75 Ah.
• The battery of the remote control has failed, repla-
ce battery.
The easy driver moves exactly in the opposite directi-
on shown by the icons on the remote control:
• The electronic system is not connected according
to the connection plan ‡.
The easydriver pulls towards one side during
manoeuvring:
• The cables to the drive motors have different
lengths.
• The drive rollers and tyres are not arranged in pa-
rallel..
• The tyre pressure or the weight distribution is Dif-
ferent.