easydriver infinity 3.5 Montageanweisung Und Bedienungsanleitung Seite 35

7. Commissioning/operation ž ‚
B5 Direction buttons
You can press any of the movement buttons singly or
together. The arrows on the buttons show the respec-
tive direction of movement.
Driving forwards
All drive units pull forwards with full
power.
Turn towards the right front*
Only the left drive units pull forwards
with full power. Only the right drive
units are blocked.
Turn towards the left front*
Only the left drive units pull forwards
with full power. Only the left drive
units are blocked.
Turn towards the right rear*
Only the left drive units pull back-
wards with full power. Only the right
drive units are blocked.
Turn towards the left rear*
Only the right drive units pull back-
wards with full power. Only the left
drive units are blocked.
Driving backwards
All drive units pull backwards with
full power.
* The inner wheels are blocked during this rotational
movement. This may cause the wheels to dig into soft
ground. Use this movement only when the ground is
sufficiently firm.
„TANGO" type right turn „TANGO" type left turn
"TANGO"-type left turn
The easydriver
manoeuvres along a curve (see Fi-
gure). The electronic system auto-
matically switches the direction of
rotation.
"TANGO"-type right turn
The easydriver
manoeuvres along a curve (see Fi-
gure). The electronic system auto-
matically switches the direction of
rotation.
Arc towards the front right
The left drive units pull forwards with
full power. The right drive units pull
forwards with reduced power.
Arc towards the front left
The right drive units pull forwards
with full power. The left drive units
pull forwards with reduced power.
Arc towards the rear right
The left drive units pull backwards
with full power. The right drive units
pull backwards with reduced power.
Arc towards the rear left
The right drive units pull backwards
with full power. The left drive units
pull backwards with reduced power.
Buttons for automatic enga-
ging / disengaging. Both but-
tons have to be pressed at the
same time. During engaging
or disengaging the related
symbol is flashing. The system will recognize the end
position of the system and indicate this by a perma-
nent enlightened symbol.
If either the engaging or disengaging operation is in-
terrupted or the end position of the system will not be
recognized an acoustic alarm will be heard ( 3 beeps)
and the related symbol will flash.
automatically
automatically
GB13