easydriver infinity 3.5 Montageanweisung Und Bedienungsanleitung Seite 37

8. Notes/warnings
Trailer battery LED, red
• Symbol not lit up: Battery voltage is in
order.
• Slow flashing: Batteries should be char-
ged .
• 1x per second, continuous flashing and
3x acoustic warning: Batteries almost
empty. Charging is essential!
• LED permanently on and 10x acoustic
warning: Batteries deeply discharged.
The battery should be charged as soon as
possible, so that it does not get damaged.
5x acoustic warning and LED flashing in red:
• Temperature of the base station is too
high. All driving functions are switched
off. Let the base station cool down! The
system can again be switched on once
the base station has cooled down.
10x acoustic warning and LED permanently red:
• Slave base station not found. Check the
voltage supply and the connection cable
when Version 3.1 is used.
Radio range indicator LED, red
• Symbol not lit up: Radio range is in order.
• 1x per second flashing: Radio range
exceeded. All driving functions are swit-
ched off. Reactivate the system by swit-
ching the remote control Off and On.
Fault in the motor drive:
• Motor drive LEDs flash and an
acoustic warning is provided
(10x). Communication with the
motor drive PC-board is not
possible. Check the connection.
Appendix A1
• The corresponding icon flashes when swivelling
in and out. The system detects the respective end
position and indicates this by permanently illumi-
nating the corresponding icons.
• If the process of swivelling in/out is interrupted or
the end position if not detected, an audible war-
ning sounds (3x) and the corresponding icon flas-
hes (you should then check the drive units).
A1 Synchronisation
Synchronisation must be performed in the event of a
functional fault or following the exchange of electro-
nic parts. Proceed as follows:
Switch OFF the remote control
(= press once) as required
Switch off the base stations as well.
Switch ON the remote control = press 2x
Keep the forwards AND backwards
button pressed during the self-test. A
constant sound signal is produced and
the trailer symbol of the remote con-
trol flashes.
Switch on the base stations.
The sound signal goes off and the trai-
ler symbol lights up permanently once
synchronisation has been completed.
Release the forwards and backwards
buttons. A short sound signal is pro-
duced.
The base station and the remote control are now syn-
chronised with each other.
The synchronisation is completed.
The remote control switches OFF automatically after
approximately 60 seconds of no buttons being pres-
sed!
GB15