Fitting The Sensor - Sentiotec Is1-Serie Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

6.3. Fitting the sensor

The room sensor is fitted in the infrared cabin about 30 cm below the ceiling or
according to the cabin manufacturer's instructions.
● Attach room sensor 1 to the cabin wall using the two 16 mm wood screws
included.
● Lay the 2-pin cable 2 in the cabin wall and secure with cable ties.
Downloaded from www.Manualslib.com
CAUTION - incorrect readings: If the room sensor is fitted too near
the heater, it will produce incorrect measured values. Maintain a mini-
mum horizontal distance of approx. 30 cm to the heater and approx.
30 cm to the cabin ceiling. Do not fit the room sensor above the infrared
heating rods.
WORLD OF WELLNESS
manuals search engine
p. 15/22
1
EN
2